Sable car GAZ-2752, 2217, 2310>> Forward suspension bracket>> Replacement of bearings and nave cuff

Replacement of bearings and nave cuff

 PERFORMANCE ORDER

We remove a wheel (see. Removal of wheels).
We turn on a nave cap (see. Adjustment of bearings of a nave).

We take out from an arm a brake hose.

Head «on 19» we turn on two bolts of fastening of a brake bracket.

Without disconnecting a brake hose, we remove a bracket and we put it on the top lever.

Having stopped a nave a core inserted between its two bolts, …

… by a big screw-driver it is turned on three screws of fastening of a brake disk to a nave.

Tapping from within with a copper hammer on the disk basis, we remove a disk.

Rasshplintovyvayem and a cap key from a regular set (or a head «on 36») we turn on a nave nut.

We remove a washer.

Having pulled on itself, we remove a nave, holding from loss an internal ring of the external bearing.

We take out an internal ring of the external bearing.

By screw-driver it is hooked and we take out a nave cuff …

… and remote ring.

We take out an internal ring of the internal bearing with rollers.

Drift...

... we beat out from a nave external rings of bearings.

We wash out a nave, a pin and other details kerosene or diesel fuel. If bearings we do not plan to replace, we wash out and we examine them. On rings and rollers there should not be cracks, corrosion, sinks and appreciable wear. On separators cracks and gaps are inadmissible. In the presence of defects we replace bearings in a set and both at once.

We press external rings of bearings.

At installation it is plentifully put on bearings Litol-24 greasing, "Lit", MS-1000 or MS - "Pendant" in a nave we put about 100 g of the same greasing.
Accurately we press a new cuff, using old as an opravka. Between working edges of a cuff also we put greasing.
We collect and establish a nave in return sequence then we regulate an inhaling of bearings (see. Adjustment of bearings of a nave).