Sable car GAZ-2752, 2217, 2310>> Zadny Bridge>> Adjustment of bearings of wheels

Adjustment of bearings of wheels

 PERFORMANCE ORDER

We hang out back wheels of the car.
We remove a wheel (see. Removal of wheels).
We remove a semi-axis (see. Semi-axis removal).
We turn on an external nut, we remove a key washer and we weaken a nut of bearings on 1/3 turns (see. Replacement of bearings of a back wheel and semi-axis cuff).
We check ease of rotation of a nave.
In case of a zadevaniye of brake shoes for drums we eliminate this malfunction (see. Adjustment of a drive of the parking brake) then we repeat adjustment.
We tighten a nut of bearings a special head from a regular set the moment of 7-10 kgfs • m, constantly rotating a nave for self-installation of rollers in bearings (see. Replacement of bearings of a back wheel and semi-axis cuff).
We turn on a nut of bearings on a corner 22–45 ° (1–2 cuts on a key washer, no more).
We establish a key washer so that the lock pin of a nut entered into its cut.
We establish and tighten an external nut the moment of 15-20 kgfs • m the same head.
After that the nave should rotate freely without люфтов, clicks and jammings.
We establish the remained details in return sequence and we fill a nave with oil (see. Oil replacement in a reducer).
We check adjustment, having passed on the car about 10 km. Nave heating is considered over 70 °C (the hand does not suffer) inadmissible. We repeat adjustment then repeatedly we check nave temperature after the same run.