Sable car GAZ-2752, 2217, 2310>> K-151 carburetor>> Adjustment of drives carburetor zaslonok

Adjustment of drives carburetor zaslonok

 PERFORMANCE ORDER

Check and adjustment of a drive of butterfly valves we carry out together with the assistant.

We remove the case of the air filter (see. Removal of the case of the air filter).
The assistant presses an accelerator pedal against the stop in a floor. Thus butterfly valves in the carburetor completely open. It is visible from above through diffuzor. If zaslonka did not open completely, …

… two keys «on 13» we weaken an inhaling of adjusting nuts.

At the pedal of an accelerator pressed against the stop a hand dovorachivay drive sector, opening butterfly valves completely. Rotating adjusting nuts, we pull the sagged cable of a drive. Once again we check adjustment (at the pedal of an accelerator pressed against the stop should not remain a free wheeling of sector) and we tighten nuts.

Do not draw a cable. Otherwise at completely open butterfly valves the pedal of an accelerator will not rest against a floor that becomes the reason of deformation of details of a drive.

We release a pedal of an accelerator and we are convinced of complete closing of butterfly valves. Otherwise …

… under the dashboard a key «on 10» we weaken an inhaling of a nut of fastening of the limiter of a course of a pedal. We move the limiter up on a cut and we tighten a nut.

We check adjustment of a drive of butterfly valves and if necessary we repeat the above-stated operations.
The air zaslonka at the drowned handle of draft of a drive should be in vertical situation, and at a handle pulling against the stop – completely to be closed. If it not so, in car salon utaplivay the handle of management of an air zaslonka against the stop.

We weaken an inhaling of the lock screw of draft of a drive of an air zaslonka.

Having pressed the lever of the starting arrangement, completely we open an air zaslonka …

… and in this situation by a screw-driver the lock screw of draft of a drive is wrapped, holding the six-sided plug from a provorachivaniye a key «on 8».

Having pressed a pedal of "gas" and having pulled the management handle, we close an air zaslonka. After that again utaplivay handle against the stop. If the zaslonka completely opened, finally we tighten the lock screw. If necessary we repeat adjustment.