Sable car GAZ-2752, 2217, 2310>> Ventilation and heating system>> Removal of the main heater

Removal of the main heater

 PERFORMANCE ORDER

We merge cooling liquid (see. Replacement of cooling liquid).
We remove a radiator of the main heater (see. Removal of a radiator of the main heater).
We remove the dashboard (see. Dashboard removal).

Having remembered or having written down a connection order, we disconnect tips of wires from the central switch of light.

We disconnect a block of wires from the switch of the electrofan of the main heater …

… and switch of the electrofan of an additional heater.

We hook a screw-driver a spring bracket …

... also we disconnect draft of the crane of a heater from the lever.

Key or head «on 10» we turn on two bolts of fastening of a branch pipe обдува a windscreen.

The near bolt to a heater needs to be turned on on 2–3 turns.

Head «on 8» we turn on саморез the bottom fastening of a branch pipe обдува a windscreen.

We remove the right branch pipe обдува with a hose.

As we remove the second branch pipe of a heater.

We disconnect a block of wires from the heater electric motor.

We remove a block of wires from conclusions of the additional resistor.

Key «on 10» we turn on a bolt of fastening of a plastic trench of a plait of wires.

Cap key «on 12» we turn on four bolts of fastening of a casing of a heater to a body. Under the bottom bolt the tip of a wire of "weight" is established.

Having a little raised a casing, we remove it together with arms.

Between arms and a body rubber laying is established.

The casing of a heater can be removed and without arms. For this purpose we remove the electrofan and we turn on two bolts of fastening of arms to a casing (see. Dismantling of the main heater). Having raised a casing on 1–2 cm, we remove it from arms, having removed from a bolt of fastening of an arm to a body a tip of a wire of "weight".
We establish a heater in such sequence: we establish casing arms with laying and we wrap bolts of their fastening. We "put on" a heater arms, at the same time getting a loop of its fastening (see. Dismantling of the main heater) for a body arm. We wrap bolts of fastening of arms to a heater and we connect wires and hoses.