Sable car GAZ-2752, 2217, 2310>> Electric equipment>> Screen wiper and windscreen washer>> Removal and screen wiper dismantling, replacement of its relay

Removal and screen wiper dismantling, replacement of its relay

 PERFORMANCE ORDER

We lift a protective cap of a nut of fastening of the lever.

Key «on 10» we turn on a nut …

… and sliding пассатижами we pull together the lever from shliyets.

Similarly we remove the second lever.

Hooking a thin screw-driver, we take out six caps of plugs of fastening of facing of the forward panel.

By Shlitseva a screw-driver it is turned on six саморезов facing fastenings …

… also we take out them together with plastic plugs.

Key «on 24» we turn on a nut of fastening of facing of the external panel.

We remove facing.

We disconnect a hose of a supply of liquid to washer nozzles from a tee (see. Removal of a washer of a windscreen).

Key «on 24» we turn on nuts of fastening of two plugs of a screen wiper ….

… also we remove sealing laying.

We disconnect a block of wires of a screen wiper in a motor compartment.

Key «on 10» we turn on two bolts of fastening of an arm of a screen wiper to a body.

We remove a screen wiper. To take out the plug of the left draft from an opening of the panel of a body, half we cover a cowl.

By screw-driver it is turned on two screws and we disconnect tips of wires from a bimetallic safety lock.

If brushes at work of a screen wiper did not come for windscreen borders, before dismantling …

… we mark a relative positioning of a motor-reducer and a crank on its shaft.

Key «on 13» we turn on a nut …

… also we remove a crank with шлицов in bulk.

We turn on three screws of fastening of an arm to a motor-reducer.

We remove the mechanism of drafts with an arm.

We collect and establish a cleaner in return sequence. Thus a crank on a shaft of a reducer we establish on the put label.
After installation of a new cleaner or replacement of a reducer probably that cleaner brushes at their movement, will fall outside the limits some glass. If shift of brushes on shlitsa did not possible to eliminate this malfunction, it is necessary to achieve the correct work of a cleaner as crank shift on a reducer shaft.
For replacement of the relay of a screen wiper …

… in a motor compartment (over a broad tank) we remove a block of wires from relay conclusions.

Key «on 10» we turn on a bolt and we remove the relay.