Governing bodies and devices
Power supply system
System of production of the fulfilled gases
Forward suspension bracket
Back suspension bracket
Check of electric chains
Replacement of fuses
Control unit (controler)
The sensor of temperature of cooling liquid
Sensor of absolute pressure
Wires of a high voltage and tips of candles
Check and replacement of the sensor of synchronization
Removal and check of the sensor of a detonation
Removal and check of the sensor of temperature
Check and replacement of coils of ignition
Check of high-voltage wires and tips of candles
Removal of spark plugs
Removal and check of the sensor of absolute pressure
Lighting, light and sound alarm systems
Screen wiper and windscreen washer
Frame, cabin, body
Ventilation and heating system
Diagnostics of malfunctions
Sable car GAZ-2752, 2217, 2310>> Electric equipment>> Ignition system>> Synchronization sensor
Synchronization sensorThe synchronization sensor – inductive type (2612.1.113 BOSCH or 406.3847113), is established at a forward end face of the engine below, on the right side and intended for synchronization of operation of the control unit with working process of the engine.
The sensor represents a rod magnet with the winding reeled up over it and concluded in the case from high-strength plastic.
When passing teeths of a disk of synchronization by a core end face on conclusions of the sensor there is a signal bearing information on frequency of rotation of a cranked shaft, and synchronization absent on a disk two teeth cause a signal impulse by which the control unit determines the top dead point (VMT) of the first cylinder.
At failure of the sensor of synchronization and its chains operation of the engine is impossible.