buy viagra online



Sable car GAZ-2752, 2217, 2310>> Electric equipment>> Generator>> Removal and generator repair

Removal and repair генератора*

 PERFORMANCE ORDER

We disconnect the storage battery.
We remove an engine mudguard (see. Removal of a mudguard of the engine).
We weaken a belt tension (see. Replacement and adjustment of a tension of a belt of a drive of auxiliary units) …

… also we remove a belt from a generator pulley.

We remove a cover from a conclusion «+» the generator.

Key «on 10» we turn on a fastening nut …

… also we remove a wire tip from a conclusion «+» the generator.

We remove a wire tip from a conclusion of the "D" generator.

Key «on 13» we turn on a nut, holding a key «on 12» a bolt of fastening of the generator to an arm of its bottom fastening.

We take out a bolt.

Key «on 13» we turn on a nut, holding a key «on 12» a bolt of fastening of the generator to the top arm.

Cap key «on 12» we weaken a bolt of the top fastening of the generator.

We take out a bolt with the plug and we remove the generator.

Key «on 10» we turn on a nut of fastening of a wire of the condenser.

Key «on 8» we turn on a nut of fastening of the condenser and we remove the condenser.

Head «on 8» we turn on two nuts …

… and, having hooked a screw-driver, we remove a plastic casing of the generator.

We disconnect a wire tip from a tension regulator.

We turn on two screws of fastening of a regulator of tension …

… also we remove it.

Key «on 8» we turn on nuts of four bolts which are pulling together covers.

Otpaivayem three conclusions of a winding of a stator from the vypryamitelny block.

Key «on 8» we turn on three nuts of fastening of the vypryamitelny block …

… also we remove it.

Head «on 24» by means of a trumpet key we turn on a nut of fastening of a pulley, thus a shaft from a provorachivaniye we hold a six-sided key «on 8» through an opening in a head...

… also we remove a washer.

Наживив a nut aflush with an end face of an axis of a rotor and holding the generator on weight for a krylchatka, in easy blows through a soft drift we beat out a pulley.

Having unscrewed a nut, we remove a pulley, a krylchatka and the persistent plug.

We mark the mutual provision of covers of the generator and we remove a back cover.

We take out a stator from a forward cover.

To small beards we beat out a shponka.

If there is no special stripper, navorachivay on a shaft a nut aflush with an end face of a shaft and a brass hammer beat out a rotor shaft from the forward bearing.

We remove from a shaft the persistent plug.

By screw-driver it is turned on four screws of fastening of a cover of the forward bearing.

Through an opravka we beat out the bearing …

… also we establish the new.

The stripper dismantled the back bearing from a rotor shaft.

The new bearing napressovyvay by means of the suitable plug, putting effort to an internal ring.

Ohmmeter we check absence of short circuit of a winding of a stator on the case (cм. Check of the disconnected chains).

We check absence of break of a chain in a stator winding.

We check absence of short circuit of a winding of a rotor on the case.

We measure resistance of a winding of excitement of a rotor which should be within 2,3–2,7 Ohm.

Submitting tension (12 In) different polarity on diodes, we check serviceability of the vypryamitelny block.

We assemble the generator in return sequence.

* dismantling and generator 2502.3771 check Is shown.