Sable car GAZ-2752, 2217, 2310>> Brake system>> Adjustment of a drive of a regulator

Adjustment of a drive of a regulator

 PERFORMANCE ORDER

We establish the equipped car on an equal platform.

Key «on 13» we turn on a nut of an axis of a rack of a regulator and we disconnect the bottom end of a rack from an arm of a beam of the back bridge.

Holding an adjusting bolt a key «on 10», a key «on 14» we turn on a bolt lock-nut.

Pressing a hand rounds of a loading spring, utaplivay the piston of a regulator and, holding him in this situation, …

… a key «on 10» we rotate an adjusting bolt, …

... establishing distance between an axis of the top end of a rack and an axis of an opening of an arm of a beam of the back bridge within 26–36 mm (for the bus) or 52–60 mm (for other updatings of the car).

Holding an adjusting bolt, we tighten its lock-nut.
We fix the bottom end of a rack on an arm of a beam of the back bridge.
After adjustment it is necessary to check regulator work for what at speed of 30-40 km/h on a firm dry paving it is vigorously pressed a brake pedal, thus the assistant should, standing sideways, to watch braking of wheels. At a serviceable regulator the small advancing of blocking of forward wheels rather back should be observed. If occurs on the contrary, follows, having unscrewed a lock-nut of an adjusting bolt, to unscrew a bolt on a half of turn. If forward wheels are blocked much earlier back, it is necessary to wrap an adjusting bolt on a half of turn and to tighten a lock-nut.