Sable car GAZ-2752, 2217, 2310>> Steering>> Replacement of bearings and plugs of pendular levers

Replacement of bearings and plugs of pendular levers

 PERFORMANCE ORDER

We work at a viewing ditch.

We disconnect from the left pendular lever longitudinal and cross-section steering drafts (see. Replacement of steering drafts and their hinges).
Flat-nose pliers rasshplintovyvay …

… and a key «on 27» we turn on the bottom nut of an axis of the lever.

We remove a steel washer, a rubber ring …

… and plastic washer.

We establish a steel washer on a place and we wrap a nut.

Thin flat-nose pliers rasshplintovyvay top nut of an axis of the lever.

Key «on 27» we turn on a nut and we leave it aflush with an axis end face.

Having inserted a core (an assembly shovel) between a longeron of a frame and a nut end face, we strike blows to the lever, shifting it from an axis cone.

Having finally unscrewed the top nut, we remove the lever, …

… I will embrace, …

… sealing rubber ring, …

… and plastic washer.

We take out a lever axis down.

Cнимаем from an axis two rasporny plugs and the sealing rubber ring placed between them.

By Opravka or the suitable plug in diameter of 30-32 mm and length not less than 130 mm it is beaten accurately out …

… needle bearings.

Having cleared and having washed out an internal cavity of an arm and other details …

… we insert and …

… we press new needle bearings so that …

… the gap between the top end face of the top bearing and the top end face of an arm was 1мм, …

… and the gap between the bottom end face of the bottom bearing and the bottom end face of an arm was 14 mm.

We grease rubber consolidations and plastic washers of Litolom-24, and an axis – transmission oil.
We establish an axis in bearings and, holding it from below, we put on it a holder, a rubber ring and a plastic washer of the top consolidation. We put on the lever a cone, we tighten also shplintuy the top nut.

We establish for the bottom end of an axis two rasporny plugs (the top plug with cuts), and between them a rubber ring.

We establish a plastic washer and a steel washer with the rubber ring put on it.
Navorachivayem a nut also we regulate effort of an inhaling (see. Adjustment of pendular levers).
We grease a lever support (see. Greasing of axes of pendular levers).
Similarly we take out an axis of the right pendular lever.

Nozhovochnym cloth …

… or with a sharp chisel we delete a fillet of the plastic plug.

The same plug-opravkoy, as for the left lever we beat out both plugs from an arm.

Having washed out a cavity of an arm and other details, …

… we insert and press new plugs.

We fill space between Litolom-24 plugs. The same greasing we put on a lever axis, rubber rings and plastic washers. We establish the lever with an axis then we regulate effort of an inhaling of a nut (see. Adjustment of pendular levers).
We connect levers to steering drafts.